Connecting to other equipment88VQT1B86Printing the PicturesBy connecting the camera directly to aprinter supporting PictBridge via the USBconnection cable (supplied), you can selectthe pictures to print and start printing on thecamera’s screen.Set print settings such as the print qualityon the printer beforehand. (Read the printeroperating instructions.)A: USB connection cable (supplied)B: AC adaptor (DMW-AC5PP; optional)• It may take time to print some pictures.Use a battery with sufficient battery power(P21) or the AC adaptor (DMW-AC5PP;optional) when you connect to a printer.• Turn the camera off before inserting orremoving the cable for the AC adaptor(DMW-AC5PP; optional).1 Turn on the camera and theprinter.2 Set the mode dial to [ ].3 Connect the camera to a printervia the USB connection cable A(supplied).• Connect the USB connection cable withthe [ ] mark facing the [2] mark onthe [DIGITAL] socket.• Hold the USB connection cable at Cand insert straight in or take straightout.• Do not use any other USB connectioncables except the supplied one.• If the mode dial is not set to [ ] whenthe camera is connected to the printer,disconnect the USB connection cable, setthe mode dial to [ ] and then connectthe USB connection cable again.(Depending on the printer, it may benecessary to turn it off and then on again.)• If a card is not inserted when the camerais connected to the PC, you can edit oraccess the picture data on the built-inmemory. If a card is inserted, you can editor access the picture data on it.• You cannot switch between the built-inmemory and the card while the camera isconnected to the printer. When you wantto switch between the built-in memory andthe card, disconnect the USB connectioncable, insert (or remove) the card andthen connect the USB connection cable tothe printer again.DIGITALAV OUTDC IN
