Panasonic NV-MD9000EN Operating Instructions Manual

Also see for NV-MD9000EN: Service manual Service manual Service manual

Contents

VCR Mode-57-VCR ModePlaying BackThe recorded scene can be played backimmediately after the recording.1 Set the [OFF/ON] Switch (50) to [ON].2 Press the [MODE] Button. (47)≥The [VCR] Lamp (48) lights up.3 Press the [6] Button (20) to rewind thetape.≥Rewind the tape to the point where youwant to start playback.≥When the tape reaches the beginning,rewinding stops automatically.4 Press the [1] Button (22) to startplayback.≥The [!] Indication appears.To Stop PlaybackPress the [∫] Button (21).OFF ONCAMERAVCR(50)CAMERAVCRMODE(47) (48)SEARCH(20)BLC(22)FADE(21)ª Adjusting the Sound VolumeUntil the [VOLUME] Indication appears, keeppressing the [PUSH] Dial (14). Then, turn the[PUSH] Dial to adjust the volume. After theadjustment, press the [PUSH] Dial to make the[VOLUME] Indication disappear.To adjust the volume with the RemoteController, press the [T] or [W] Button to displaythe [VOLUME] Indication. Press the [T] Buttonto increase the volume or press the [W] Buttonto decrease the volume. The [VOLUME]Indication goes off a few seconds after theadjustment is finished.≥The sound volume cannot be adjusted usingthe Remote Controller in Playback ZoomMode. (-59-)≥If a cassette recorded with a copyrightprotection signal is played back, the picture isdistorted by mosaic-like patterns.≥For other notes concerning this item, see -66-.Finding a Scene You Want to PlayBackª Cue/Review PlaybackIf the [5] Button (23) or [6] Button (20) ispressed during Playback, it turns to CuePlayback A or Review Playback B.≥If the Button is held continuously, it turns toCue Playback or Review Playback until yourelease it.ª Variable Speed Search FunctionThe speed of Cue Playback or Review Playbackcan be varied.1 During playback, press the [1] Button(22).≥The [1k!] Indication appears.W.B/SHUTTER/IRISPUSHVOL/JOG(14)SEARCHSEARCH(20)(23)A BBLC(22)