17Setting Date and TimeSince the internal clock of the Movie Camera has a slight imprecision, makesure to check the time before recording.1 Set [OTHER FUNCTIONS] >> [CLOCK SET] >> [YES].2 Press the [PUSH] Dial to select [YEAR]/[MONTH]/[DAY]/[HOUR]/[MIN.] and turn to set it to a desired value.≥Year will cycle in the order shown below.2000, 2001, ..., 2089, 2000, ...3 Press the [MENU] Button to finish setting the date and time.≥The clock operation starts from [00] second.≥The Menu will disappear when the [MENU] Button is pressed again.≥If the built-in battery is weak, the [0] Indication 1 flashes. In this case,charge the built-in battery.≥The clock employs the 24-hour system.~~~~~~~~~~~~~~~~~~~~~~~~~Internal Lithium Battery Recharge≥The internal lithium battery sustains the operation of the clock. When the[0] Indication flashes, the internal lithium battery is near exhaustion.1 Connect the AC adaptor to the Movie Camera with the powerturned off and then connect to the AC Mains socket.≥After charging for 4 hours, the built-in lithium battery can power theclock for approximately 3 months..........................................................................................................................WARNINGTHE LITHIUM BATTERY IN THIS EQUIPMENT MUST ONLY BEREPLACED BY QUALIFIED PERSONNEL. WHEN NECESSARY,CONTACT YOUR LOCAL PANASONIC SUPPLIER..........................................................................................................................~~~~~~~~~~~~~~~~~~~~~~~~~LP ModeA desired recording speed can be selected with [REC SPEED] on the[RECORDING SETUP] Sub-Menu. (When recording to tape only)If LP Mode is selected, the recording time becomes 1.5 times longerthan that of SP Mode.Although the image quality does not decrease with the LP Mode recording,mosaic-pattern noise may appear on a playback image, or some normalfunctions may be restricted.≥The contents that are recorded in LP Mode are not completely compatiblewith other equipment.≥Audio dubbing is not possible with LP Mode. (l 35)~~~~~~~~~~~~~~~~~~~~~~~~~Audio Recording ModeThe sound quality of the recorded sound can be selected with [AUDIO REC]on the [RECORDING SETUP] Sub-Menu.High sound-quality recording is possible with “16 bit 48 kHz 2 track” Mode.With the “12 bit 32 kHz 4 track” Mode, the original sound can be recorded on2 tracks in stereo, while the other 2 tracks can be used for Audio Dubbing.11, 31, 2MENUSHUTTER/IRIS/ VOL/JOGPUSHCLOCK SETPRESS MENU TO RETURNYEAR 2002MONTH 10DAY 08HOUR 14MIN. 301