Before Use-7-3 Insert the Battery Holder into the Remote Controller.≥When the button-type battery is exhausted, replace it with anew CR2025 battery. (A battery is normally expected to lastabout 1 year. However, it depends on operationfrequency.)≥Make sure to match the poles correctly when inserting thebattery.ª Using the Remote Controller1 Direct the Remote Controller to the Remote ControlSensor (48) of the Movie Camera and press anappropriate button.≥Distance from the Movie Camera: Within approximately5 metres≥Angle: Within approximately 5o in the upward, and 15o inthe downward and horizontal directions from the centralaxis≥The above operative ranges are for indoor use. Outdoorsor under strong light, the Movie Camera may not operateproperly even within the above ranges.≥Within a 1-metre range, you can also use the RemoteController on the LCD Monitor side of the Movie Camera.Selecting Remote Controller ModesWhen 2 Movie Cameras are used simultaneously, they canbe operated individually by selecting different RemoteController Modes.≥If the Remote Controller Mode of the Movie Camera andthat of the Remote Controller do not match, [REMOTE]Indication is displayed.Setup on the Movie Camera:Set [REMOTE] on the [OTHER FUNCTIONS] Sub-Menu tothe desired Remote Controller Mode. (-11-)WARNING“THE LITHIUM BATTERY IS A CRITICALCOMPONENT (TYPE NUMBER CR2025MANUFACTURED BY PANASONIC).IT MUST NEVER BE SUBJECTED TO EXCESSIVEHEAT OR DISCHARGE. IT MUST THEREFORE ONLYBE FITTED IN EQUIPMENT DESIGNEDSPECIFICALLY FOR ITS USE.REPLACEMENT BATTERIES MUST BE OF THE SAMETYPE AND MANUFACTURER.THEY MUST BE FITTED IN THE SAME MANNER ANDLOCATION AS THE ORIGINAL BATTERY, WITH THECORRECT POLARITY CONNECTIONS OBSERVED.DO NOT ATTEMPT TO RE-CHARGE THE OLDBATTERY OR RE-USE IT FOR ANY OTHERPURPOSE. IT SHOULD BE DISPOSED OF IN WASTEPRODUCTS DESTINED FOR BURIAL RATHER THANINCINERATION.”5˚15˚15˚15˚ (48)Setup on the Remote Controller:[VCR1]:Press the [D] Button and [∫] Button simultaneously. 1[VCR2]:Press the [E] Button and [∫] Button simultaneously. 2≥When the battery in the Remote Controller is replaced, themode is automatically reset to [VCR1] Mode.Power Supplyª Using the AC Adaptor1 Connect the DC Input Lead to the Movie Camera.2 Connect the DC Input Lead to the AC Adaptor.3 Connect the AC Mains Lead to the AC Adaptor and theAC mains socket.≥The AC Mains Lead’s outlet plug does not fit entirely intothe AC Adaptor socket. A gap will remain as shown 1.≥Before connecting or disconnecting the power supply,set the [OFF/ON/MODE] Switch on the Movie Camera to[OFF] and make sure that [CAMERA/VCR/CARD P.B]Lamps are not lit.ª Using the BatteryBefore use, fully charge the Battery.1 Attach the Battery to the AC Adaptor and charge it.≥Since the Battery will not be charged when the DC InputLead is connected to the AC Adaptor, disconnect it fromthe AC Adaptor.≥After the [POWER] Lamp has lighted, the [CHARGE]Lamp flashes.2 When the [100%] Lamp 1 on the AC Adaptor islighted, charging is finished.≥When the [QUICK] Lamp 2 is lighted, approximately50 minutes of continuous recording is possible.≥The [QUICK] Lamp flashes and then remains lighted onlywhen charging a quick-charge type battery.INDEX INDEXSELECTSTOPK L∫STILL ADVTWPAUSE STILL ADV6 1 5;E D2 11QUICK 100%CHARGEPOWER12