Before Use-8-3 Attach the charged Battery to the Movie Camera.Disconnecting the Power SourceSet the [OFF/ON/MODE] Switch (33) to [OFF] and, whilepressing the [PUSH BATT] Button (50), slide the Battery orDC Input Lead upward to disconnect it.ª Using the Car Battery ChargerIf you use the Car Battery Charger (VW-KBD2E; optional),you can supply power to the Movie Camera and charge thebattery inside your car. For further information, refer to theinstruction manual of the Car Battery Charger.Be sure to start the car engine before you connect the CarBattery Charger, otherwise the fuse may blow.≥For other notes concerning this item, see -41-.Charging Time and Available Recording TimeA Charging TimeB Maximum Continuous Recording TimeC Intermittent Recording Time(Intermittent Recording Time is the available recording timewith repeated recording and stopping actions.)“1h10min.” indicates 1 hour and 10 minutes.≥Battery VSB0419 is supplied.≥The times shown in the table are approximate times. Thenumbers in parentheses indicate the recording time whenthe LCD Monitor is used. In actual use, the availablerecording time may be shorter.≥The times shown in the table are for continuous recordingat a temperature of 20oC and humidity of 60%. If theBattery is charged at a higher or lower temperature, thecharging time may be longer.CGP-D14SCGP-D210A 1h30min.B 2h.(1h40min.)C 1h.(50min.)CGR-D16SCGR-D220VSB0419A 1h10min.B 2h20min.(2h.)C 1h10min.(1h.)CGP-D28SCGP-D320A 2h.B 4h5min.(3h25min.)C 2h5min.(1h45min.)CGR-D53SCGR-D815A 4h30min.B 7h40min.(6h25min.)C 3h50min.(3h15min.)CGA-D54S A 3h.B 7h55min.(6h35min.)C 4h.(3h20min.)(50)(33)PUSHBATTOFFONMODELens Cap and Grip Beltª Attach the Lens CapTo protect the Lens surface, attach the Lens Cap.1 Pass the end of the Lens Cap String through the LensCap String Holder.2 Pass the other end of the String through the loopmade by the String itself and pull it toward thedirection indicated by an arrow.≥The removed Lens Cap can be hooked onto the Grip Belt.(When you are not recording, be sure to keep the Lens Capattached to the Lens for protection.)ª Adjust the Grip BeltAdjust the length of the Grip Belt to the size of your hand.1 Detach the tip of the Grip Belt.2 Slide the pad to obtain the optimum length.3 Reattach the Grip Belt.ª To Use as the Free Style Grip BeltUsing the Grip Belt as the Free Style Grip Belt makes iteasier to handle and carry the Movie Camera. It is moreconvenient to use with the Free Style Remote Controller.