20ENGLISHSupplying Power with the BatteryCharge the Battery before using it.1 Set the [CAMERA/OFF/VCR] Switch to [OFF].2 Insert the Battery with its top (so that thearrow points upward) into the top BatteryHolder and press the bottom of it toward theMovie Camera until it locks with a click.3 Connect the AC Adaptor to the[DC IN] Socket on the Movie Camera.4 Connect the AC Mains Lead to the AC Adaptorand an AC mains socket.≥The [CHARGE] Lamp 1 flashes and charging starts.≥If the [CHARGE] Lamp does not flash even though theBattery is attached, remove the Battery and thenre-attach it.Removing the Battery from the Movie CameraHold the Battery firmly to prevent it from dropping and pull it offwhile sliding the [2BATTERY EJECT] Lever 2 in the directionof the arrow.≥Before removing the Battery, set the [CAMERA/OFF/VCR]Switch to [OFF].∫ Charging Lamp [CHARGE]Flashing: During chargingFlashing with [CAMERA] Lamp: When error occursLit: VCR ModeOff: The Battery is fully charged.≥Set the [CAMERA/OFF/VCR] Switch to [OFF] to charge theBattery.≥Charge the Battery at a room temperature between 10xC and30xC.≥During recording or charging, the Battery becomes warm.However, this is normal.≥To ensure precise indication of the remaining battery power,always use a fully charged Battery when attaching a Battery.431CAMERAOFFVCR221INFO-WINDOWCAMERA V C RCHARGE ! !"#$%&'(!)1 [`^jbo^LlccLs`o] !" [lcc] 2 !"#$%&'( )*!"# !" !"#$%&' !"#$3 !"#$"%&'()*+ [a`=fk] 4 !"#$%&' (&)* !"+,-≥ [`e^odb] 1 !"#$%&≥ !"#$%&'([`e^odb] !"#$%& !"#$%&'()* !"#$%&'( !"#$%&'()*%+,-./012[2 _^qqbovbgb`q] 2 !"#$%≥ !"[`^jbo^LlccLs`o] !"[lcc]∫ !" [`e^odb] ! [`^jbo^] !" # !"# !" !"#≥ [`^jbo^LlccLs`o] !" [lcc] !!"#≥ !"#$%&' NM–PM≥ !"#$%#&'()%*+,-./0≥ !"#$% &'()*'+,-./0'(1.23 !"#$#%&