40ENGLISH125341<EJECT3OPEN26 34LOCKInserting/Ejecting the Cassette1 Connect the AC Adaptor or attach a chargedBattery. (m 18, 20)2 Turn the cog wheel 1 to tighten the tape.3 Slide the [3OPEN] Lever to the left andsimultaneously open the LCD Monitor in thedirection of the arrow approximately 90x.≥Be sure to keep the LCD Monitor in its vertical position,so that the Cassette Compartment Cover, when it opens,does not hit the LCD Monitor.4 Press the [< EJECT] Button.5 Insert the cassette with the cassette window2 facing outward and push it all the way in.6 Close the Cassette Compartment by pressingthe [LOCK] Button.≥If the AC Adaptor or Battery is used to supply power, it ispossible to insert or eject the cassette without turning on theMovie Camera.≥If a cassette with broken out erasure prevention tab isinserted, the [Y] Indication flashes.≥You will hear noise of tightening the tape when you insert thecassette, and noise of rewinding the tape when you close thecassette compartment. This is not a malfunction.∫ Preventing Accidental Erasure of Recordings≥Recording on a previously recorded cassette erases theexisting scenes and sound.≥To protect important recordings against accidental erasure,use a screwdriver to break out the tab 3 on the cassette(some cassettes have sliding-type tabs).≥To be able to record again on a protected cassette, firmlycover the hole where the tab was with two layers of adhesivetape 4.L !"#1 !"#$%&'()*)+,l NUOM2 ! 1 !"#$3 ! [3lmbk] !"#$%&'()* !"#$ VM≥ !"#$%&'()*+,-./-012345 !"#$%&'()*+,-.4 [ < bgb`q] !5 !"#$ !"%&'2 !"#$%&6 !"#$%&'( [il`h] ≥ !"#$%&'"()*'+,-./0123456 !"#$%&≥ !"#$%&'()*+,-./ [Y] !"#≥ !"#$%&'("#)*+,-.%/0"#1 !"#$%&'()*+,-./01234-∫ !"#$%&'(≥ !"#$%&'()"%*+,-./0#1234≥ !"#$%&'()*+,-./012345678 ! 3 !"#$%&'()*≥ !"#$%&'()*+,- ./0%14 ! !"#$%&'