23 ENGLISHPowering off the projectorPress the POWER OFF “ ” button.Select “OK” with or button andpress the ENTER button.(or press the POWER OFF “ ” buttonagain.)The projection of the image stops, and the powerindicator of the main unit lights up orange. (Thecooling fan keeps running.)Wait until the power indicator of themain unit turns to red (i.e., until thecooling fan stops).Press the “ ” marked side of the MAINPOWER switch to remove all powerfrom the projector.• The projector consumes approximately 15watts of power even in standby mode afterthe cooling fan stops. (Power indicator litin red)• If you re-power the projector after shuttingoff the main power inadvertently, theprojection lamp may remain unlit. Pleaseturn the power on again after a while.Note• When the lamp has been cooled by thedirect power OFF function, it sometimestakes longer than usual for the lamp tolight up again.• While the cooling fan is operating, do notplace the projector inside a box or bag.• The operation time of the cooling fan willbe less if fewer than 4 minutes haveelapsed since the power was turned on.NoteDirect power off functionThe power supplied internally causes the coolingfan to continue operating and cool off in the eventthat the power has failed or even after the powercord is accidentally disconnected immediately afterthe power has been turned off.• Do not turn the power supply off andthen immediately back on again.Turning on the power supply will not lightup the light source lamp if the lamp is inthe process of cooling down after turningoff the power supply. To light up the lamp,turn on the power supply again when thelamp has been cooled sufficiently.Turning on the power supply with the lampin the hot condition may shorten the lamplife.AttentionDownloaded From projector-manual.com Panasonic Manuals