Panasonic PT-D5600E Operating Instructions Manual

Also see for PT-D5600E - XGA DLP Projector: Setup and operation manual Operating instructions Service manual

Contents

Panasonic PT-D5600E Operating Instructions Manual Manual pdf 31 page image

31 ENGLISHHow to use ADVANCED MENUADVANCED MENUSELSCT RETRNINPUT RESOLUTIONBLANKINGDIGITAL CINEMA REALITY1CLAMP POS.SXGAXGASXGA MODERASTER POSITIONXGA MODEENTERINPUT RESOLUTIONInput resolution adjustment achieves the bestimage when the screen flickers or halo is observedaround the contour.: These select the items listed below.: These select the value.“TOTAL DOTS”, “DISPLAY DOTS”, “TOTALLINES” and “DISPLAY LINES”Each item automatically displays a value inresponse to the type of the input signal. If verticalstripes appear on the screen or the image is partlymissing, increase or decrease the displayed valuewhile observing the screen to achieve the optimalvalue.CLAMP POS.(For RGB/ YPB PR signals only)Use the clamp position adjustment to achieve theoptimal value when dark areas of the image arecrushed or displayed in green.Adjust with the buttons.The value changes from 0 to 255.The optimal value for the clamp position adjustment• If dark areas are crushed:The optimal value is the point where the darkarea is best improved.• If the dark areas are displayed in green:The optimal value is the point where thegreen area becomes dark and clear.DIGITAL CINEMA REALITY(Only for input of S-Video/ Video/ YPB PR [480i,576i] signals.)ON: Set at ON when you need to faithfullycapture images shot at 24 frames persecond as in movies.OFF: Set at OFF when unnatural images areobtained in the ON status.BLANKINGYou can perform fine adjustments for blanking ifnoise appears at the ends of the screen or theimage protrudes out of the screen during imageprojection using a video deck and so on.: Select the UPPER, LOWER, LEFT orRIGHT adjustment.: Adjust the blanking width.• The abovementioned vertical stripeswill not appear on the screen when allwhite signals are input.• The picture may be distorted during theadjusting operation, but this is not a fault.• The input resolution can be adjustedonly when RGB signal input is appliedwith RGB1 and RGB2 IN.• Automatic adjustment is not availableif signals having a dot clock frequencyof more than 108 MHz are supplied.Note• The clamp position can be adjustedonly when the RGB signal input isapplied with RGB1 and RGB2 IN.NoteFor lower adjustmentFor upper adjustmentFor right adjustmentFor left adjustmentDownloaded From projector-manual.com Panasonic Manuals