Panasonic PT-D5600E Operating Instructions Manual

Also see for PT-D5600E - XGA DLP Projector: Setup and operation manual Operating instructions Service manual

Contents

Panasonic PT-D5600E Operating Instructions Manual Manual pdf 38 page image

38Pin assignments and signal namesCommunication conditions (Factory setting)Basic formatTransmission from the computer begins with STX, then the ID, command, parameter, and ETX are sent in thisorder. Add parameters according to the details of control.The main unit is equipped with SERIAL terminals located in its terminal section on the side, and this terminal iscompliant with RS232C. Also a serial output terminal is provided to enable plural projector control.Examples of connectionSingle projector Plural projectorsPCD-Sub 9-pin(male)Communication cableD-Sub 9-pin(male)D-Sub 9-pin(female)Communication cable D-Sub 9-pin(female)D-Sub 9-pin(female)D-Sub 9-pin(male)D-Sub 9-pin(male)Using the serial terminalsStart(1 byte) ID designate3 commandcharacters (3 bytes)Parameter(undefined length)End(1 byte)Two IDcharacters(2 bytes) Semicolon(1 byte)Colon(1 byte)ZZ, 1 to 64 and 0A to 0ZSTX C1 C2 C3 : P1 P2 Pn ETXA D I 1 I 2 ;(2 bytes)• No command can be sent or received for 10 to 60 seconds after the lamp starts lighting. Try sendingany command after that period has elapsed.• When sending several commands, be sure to wait for more than 0.5 seconds after receiving aresponse from the projector, and then send the next command. When sending commands withoutparameters, a colon (:) is not necessary.Attention• If an unworkable command is received, the projector will send an “ER401” response to the computer.• If an invalid command is received, the projector will send an “ER402” response to the computer.• Projector ID supported on the RS232C interface is ZZ (ALL) and a group of 1 to 64 and 0A to 0Z.• If a command is sent with a projector ID specified, the projector will return answer back only in the following cases:If it coincides with the projector ID,ID specification is ALL and VPS-SYSTEM is the master, orID specification is group and Group is the master.• In the hexadecimal format, STX has the character code 02 and ETX the character code 03.NotePCD-Sub 9-pin (female)D-Sub 9-pin (male) Communication cableD-Sub 9-pin (female),external appearanceSerial input terminalPin No. Signal nameTXDRXDGNDCTSRTSDescriptionNCSend dataReceive dataConnected internallyGroundNCConnected internallyNCD-Sub 9-pin (male),external appearanceSerial output terminalPin No. Signal nameRXDTXDGNDRTSCTSDescriptionNCReceive dataSend dataNCGroundNCConnected internallyNCSignal levelSynchronization methodBaud rateParityCharacter lengthStop bitX parameterS parameterRS232C compliantStart-stop synchronization9 600bpsNone8 bits1 bitNoneNoneDownloaded From projector-manual.com Panasonic Manuals