[ADVANCED MENU]52 - ENGLISHSettings[INPUT RESOLUTION]You can adjust to achieve an optimal image whenthere is a flickering image or smeared outlines.1) Press ▲▼ to select [INPUTRESOLUTION].2) Press the button.z The [INPUT RESOLUTION] screen isdisplayed.3) Press ▲▼ to select [TOTAL DOTS],[DISPLAY DOTS], [TOTAL LINES], or[DISPLAY LINES], and press ◀▶ toadjust it.z Values corresponding to the input signal aredisplayed automatically for each item. Changethe displayed values and adjust to the optimalpoint viewing the screen when there is a verticalbanding or missing in the screen.Notez Previously mentioned vertical banding will not occurwith all white signal input.z The image may be disrupted while performing theadjustment, but it is not a malfunction.z [INPUT RESOLUTION] can be adjusted only whenan RGB signal is input in the terminalor the terminal.z A signal with dot clock frequency with 150 MHz orhigher cannot be adjusted.[CLAMP POSITION]You can adjust the optimal point when the black partof the image is blunt or it has turned green.1) Press ▲▼ to select [CLAMPPOSITION].2) Press ◀▶ to adjust the level.z Adjustment value will change between 0 and255.z Optimal value of clamp position adjustmentWhen the black part is blunt:The point where bluntness of the black partimproves the most is the optimal value.When the black part is green:The point where the green part becomes black,and the bluntness has improved is the optimalvalue.Notez [CLAMP POSITION] can be adjusted only when asignal is input in or .[EDGE BLENDING]The edge blending function allows multiple projectorimages to be seamlessly overlapped by using theinclination of the brightness at the overlapped area.1) Press ▲▼ to select [EDGEBLENDING].2) Press ◀▶ to switch [EDGEBLENDING].z The setting will change as follows each timeyou press the button.[OFF] [ON][OFF] Sets the edge blending function tooff.[ON] Sets the edge blending function toon.3) Press the button when [ON]is selected.z The [EDGE BLENDING] screen is displayed.4) Press ▲▼ to specify the location to becorrected.z When joining at top: Set [UPPER] to [ON].z When joining at bottom: Set [LOWER] to [ON].z When joining at left: Set [LEFT] to [ON].z When joining at right: Set [RIGHT] to [ON].5) Press ◀▶ to switch [ON] and [OFF].6) Press ▲▼ to select [START] or[WIDTH], and press ◀▶ to adjust thestarting point and the overlap width.■ To display the adjustment marker7) Press ▲▼ to select [MARKER].
