[PROJECTOR SETUP] menu62 - ENGLISHSettings3) When the confirmation is displayed,select [OK] or [CANCEL], and pressthe button.Notez The speed of the fan is raised and the operationsound will become louder when this is set to [ON].[COOLING CONDITION]You can change the fan control depending on thedirection of projection.Set [COOLING CONDITION] correctly in accordancewith the direction of projection referencing thefollowing figure. It may shorten the life of the lamp ifused in incorrect setting.1) Press ▲▼ to select [COOLINGCONDITION].2) Press the button.z The [COOLING CONDITION] screen isdisplayed.3) Press ▲▼ to select the coolingcondition.[VERTICAL UPSETTING][FLOOR SETTING] [CEILING SETTING][VERTICALDOWN SETTING]Projection direction4) Press the button.5) When the confirmation is displayed,select [OK] or [CANCEL], and pressthe button.[LAMP SELECT]You can set the brightness using the two luminouslamps built inside the projector to dual-lamp or single-lamp brightness in accordance with the condition orpurpose of the usage. Setting [SINGLE] automaticallyswitches the lamp to be turned on based on theduration of use.1) Press ▲▼ to select [LAMP SELECT].2) Press ◀▶ to switch [LAMP SELECT].z The setting will change as follows each timeyou press the button.[DUAL] [SINGLE][LAMP2] [LAMP1][DUAL] Two lamps will light.[SINGLE]One lamp will light. (The lampwith shorter duration of use isautomatically selected.)[LAMP1] Lamp unit 1 will light continuously.[LAMP2] Lamp unit 2 will light continuously.3) Press the button.Notez In the [SINGLE], [LAMP1] or [LAMP2] mode,one lamp remains off or the currently active lampexceeds 2 000 hours of cumulative operating time(when [HIGH] is selected as the [LAMP POWER]setting), the other lamp will light. In the [DUAL]mode, one lamp remains off or the currently activelamp exceeds 2 000 hours of cumulative operatingtime (when [HIGH] is selected as the [LAMPPOWER] setting), the other lamp alone will light.However, if both lamps remain off or the 2 000hours of cumulative operating time (when [HIGH] isselected as the [LAMP POWER] setting).z The text colors of the items indicate the status.Green Current settingYellow Current setting(When there is a lamp that cannot turn on orfailed to turn on)Red Lamp that has failed to turn onWhite Any other statusz If the projector is repeatedly used for short periodsof time, the lamps will need to be replaced morefrequently.
