Panasonic PT-JX200GBE Operating Instructions Manual

Also see for PT-JX200GBE: Operating instructions

Contents

Chapter 5 Operations — Web control functionENGLISH - 117E-mail error information is displayed if periodic E-mail sending fails.Notef [Access error log]/[E-mail error log] displays the recent several hundreds of accesses/requests. All information may not be displayed whenmany accesses/requests are made at a time.f When information in [Access error log]/[E-mail error log] exceeds a certain amount, they are erased from the oldest.f Check [Access error log]/[E-mail error log] periodically.[Basic control] pageClick [Projector control] → [Basic control].1234561 [INPUT]Switches the input.2 [VOLUME]Adjusts the volume.3 [BALANCE]Adjusts the right/left audio balance.4 [PICTURE MODE]Switches the picture mode.5 [AV MUTE]Switches AV mute on/off.6 [POWER]Switches on/off the power.Attentionf When you turn on the projector, be careful so that the eyes of people around the projector are not exposed to the sudden light from the lightsource.Or operate the projector only if the eyes of people around the projector are not exposed to the light from the light source even whenprojection starts suddenly.Notef When the [NETWORK] menu → [WIRELESS LAN] (x page 83) is set to [M-DIRECT] or [SIMPLE] and web control is performed viawireless LAN, switching to [MEMORY VIEWER] or [MIRRORING} disconnects the wireless LAN and disables later web control operations.f When the [NETWORK] menu → [WIRELESS LAN] (x page 83) is set to [M-DIRECT] or [SIMPLE] and web control is performed viawireless LAN, turning on the power and starting projection with MIRRORING input disconnects the wireless LAN and disables later webcontrol operations.g When the [SETUP] menu → [STARTUP INPUT SELECT] (x page 76) is set to [LAST USED]Turn off the power when the input other than MIRRORING is selected.If the projector is in standby mode with MIRRORING input, switch the input to other than MIRRORING in the [Basic control] page beforeturning on the power.g When the [SETUP] menu → [STARTUP INPUT SELECT] (x page 76) is set to [MIRRORING]Switch the input to other than MIRRORING using the remote control after projection has been started or set [STARTUP INPUT SELECT]to other than [MIRRORING] beforehand.