ADJ-5SECTION 3 ADJUSTMENTS < RZ31K/RS30K>2) Adjust the horizontal position by turning the H adjustment screw.3) Adjust the vertical position by turning two V adjustment screws in thesame direction.4) Adjust the tilt by turning two V adjustment screws in the opposite direction.5) Repeat steps 2) to 4), until the green and red lines converge properly.6) After completing the adjustment, tighten 4 fixed screws on the DMD plate.H-Adj. Screw(R)H-Adj. Screw(G)GREEN 1/5NEXTENTERLoosen 4 screws 45-degree turnGREEN 5/5ENDENTERFasten 4 screwsRED 1/5NEXTENTERLoosen 4 screws 45-degree turnRED 5/5ENDENTERFasten 4 screwsGREEN 2/5NEXTENTERAdjust horizontalGREEN 3/5NEXTENTERAdjust verticalGREEN 4/5NEXTENTERAdjust tiltRED 2/5NEXTENTERAdjust horizontalRED 3/5NEXTENTERAdjust verticalRED 4/5NEXTENTERAdjust tiltGREEN 2/5NEXTENTERAdjust horizontalGREEN 3/5NEXTENTERAdjust verticalGREEN 4/5NEXTENTERAdjust tiltRED 2/5NEXTENTERAdjust horizontalRED 3/5NEXTENTERAdjust verticalRED 4/5NEXTENTERAdjust tiltGREEN 2/5NEXTENTERAdjust horizontalGREEN 3/5NEXTENTERAdjust verticalGREEN 4/5NEXTENTERAdjust tiltRED 2/5NEXTENTERAdjust horizontalRED 3/5NEXTENTERAdjust verticalRED 4/5NEXTENTERAdjust tiltV-Adj. Screw(R)V-Adj. Screw(G)V-Adj. Screw(R)V-Adj. Screw(G)