INF-2SECTION 1 SERVICE INFORMATION<RZ31K/RS30K>Chapter 1Preparation — About your projectorENGLISH - 27About your projectorRemote control1264758910313121120141516231718192122FrontTopBottomA strap can be attacheddepending on the usage.1Remote control indicatorBlinks if any button in the remote control is pressed.2Power on <b> buttonSets the projector to projection mode when the POWER> switch on the projector is set to and the poweris turned off (standby mode).3Power standby <v> buttonSets the projector to the state where the projector is turnedoff (standby mode) when the switch on theprojector is set to and in projection mode.4asqwbuttonsUsed to navigate through the menu screen.5 buttonSwitches the on-screen display function on (display) oroff (hide).6 buttonAutomatically adjusts the image display position while projectingthe image.[PROGRESS] is displayed while in automatic adjustment.7 buttonSwitches the aspect ratio of the image.8Number (<0> - <9>) buttonsUsed for entering an ID number or a password in a multipleprojector environment.9 buttonDisplays the projector information.10 buttonPressing this button lights up the remote control buttons. Thelights will go off when the remote control operation goes idle for10 seconds.11 buttonDisplays the input selection screen.12Input selection buttons (, , , , , , )Switches the input signal to project. (xpage 69)The button, the button, and the button are not used with the projector.13 buttonUsed to temporarily turn off the image.14 buttonDisplays the test pattern.15Lens buttons (, , )Adjusts the projection lens.16 buttonAssigns a frequently used operation as a shortcut button.17 buttonResets the content of the sub-menu to the factory default.18 buttonSets the ID number of the remote control in a multipleprojectorenvironment.19 buttonUsed to simultaneously control all the projectors with asingle remote control in a multiple projector environment.20 buttonUsed to prevent unintended operation by careless pressing ofthe buttons and prevent draining the remote control batteries.Operation of each button on the remote control is disabled bysliding the button toward the arrow.21Remote control signal transmitter22Remote control wired terminalThis is a terminal used to connect to the projector via a cablewhen the remote control is used as a wired remote control.23Strap holeAttentionfDo not drop the remote control.1. The name of each part1. 1. Remote controls