DIS-6SECTION 2 DISASSEMBLY P ROCEDURES < RZ31K/RS30K>2. Disassembly Instructions[ Caution ]• Before disassembly of the projector, turn off the power switch and disconnect the power plug from the wall outlet.[Note]• During the disassemble work, please wear gloves to protect your hands from metal parts and shield plate.• Electrical parts such as PCBs, may get damaged by electro-statics discharge and surges which affects the set reliability.Please take care for electro-static discharges by using grounded wrist straps to release the electricity from the body.• When tore off sticky tapes, use a new thing without reusing it on the occasion of assembling.2. 1. Fine coaxial cable connector2. 1. 1. Installation requirements• Fine coaxial cable are connected connector DG-P.C.Board (connector DG21-DG26) and FM-P.C.Board (connectorFM1,FM2).• Connect the black mesh sleeve side to FM-P.C.Board. Please be careful when connecting.Black mesh sleeve side(Connect to FM-P.C.B)Fine coaxial cable (50pin)Fine coaxial cable (40pin)Signal blockDG-P.C.Boardconnector DG21-DG26DMD blockFM-P.C.Board[B]/[G]/[R]connector FM1 and FM2Note:To prevent misconnecting of the fine coaxial cables, it is recommended to mark up with magic pen on the connector