7Before Use1 Undo the two strap endsfrom their buckles.2 Thread the strap endsthrough the StrapAttachment Rings.3 Reinsert the strap ends through theirbuckles.• Make sure the strapsare not twisted.Before Using1 Press LCD-OPEN to unlock the LCDmonitor, and swing it fully open.2 Slide TAPE EJECT to open theCassette Compartment Cover.3 Insert a cassette record tab up,window side facing out.4 Press PUSH CLOSE to close theCassette Compartment Cover.Note• When inserting the cassette, make sure it is facing the right direction and then push itin completely.Easy Cassette Eject/Insertion• If the Palmcorder is connected to a powersource, the cassette can be inserted andejected without turning the Palmcorderon.• To remove the cassette...Slide TAPE EJECT to open the CassetteCompartment Cover and pull the cassettetape straight out.1LCD-OPEN Cassette CompartmentCover2TAPE EJECT4PUSHCLOSEBefore you begin• Connect the Palmcorder to a powersource. (pp. 13, 14)1 23OR1 Loosen the strap from the Buckle andcreate a loop.2 Pull the strap firmly through theBuckle to shorten or lengthen thestrap. 1Adjust the LengthAdjust the length of the Hand Strap to thesize of your hand as illustrated.Attaching the Lens Cap Cord to the HandStrap:Remove the Hand Strap from the frontclasp and thread the Strap through the loopin the Lens Cap Cord.Reattach the Hand Strap.Lens CapAttaching the Shoulder Strap213Attaching the Lens Cap Strap:Thread the Lens Cap Strap through theStrap Attachment Ring as shown.Hand StrapHand StrapDV102.p 5-9.p65 02/03/05, 12:557