With a PC-64-For Macintosh1 Turn on Computer and start up Macintosh.2 Insert supplied CD-ROM into the CD-ROMdrive.3 Double click the CD-ROM icon that appears.4 Double click [ArcSoft].5 Double click [PhotoImpression] (or[PhotoBase] or [PanoramaMaker] or[PhotoPrinter]).6 Double click [English] or [French].7 Double click [PhotoImpression Installer] (or[PhotoBase Installer] or[PanoramaMaker Installer] or[PhotoPrinter Installer]).8 Follow the instructions on the computerscreen until the installation is complete.ª To start software in ArcSoft SoftwareSuite1 Select [Start] >> [All Programs (Programs)]>> [ArcSoft Software Suite] >>[Panorama Maker 3] (or [PhotoBase 4] or[PhotoImpression 4] or [PhotoPrinter 4]).Refer to Help information about applicationoperations and other Error messages.For Information on ArcSoft Software:TEL: 1-510-440-9901Web Site: www.arcsoft.comTo disconnect USB cable safelyIf USB cable is disconnected while computer ison, error dialog box may appear. In such a caseclick [OK] and close the dialog box. By followingthe steps below you can disconnect the cablesafely.1 Double click the icon in task tray.≥Hardware disconnect dialog box appears.2 Select [USB Mass Storage Device] and click[Stop].3 Verify [Matshita DVC USB Device] isselected and click [OK].≥You can safely disconnect the cable.Note on the driver name displayedThe driver name displayed will differ dependingon your OS, operating environment and the modeof the Camcorder.Windows XP/2000:(When the Camcorder is in Tape Recording modeor Tape Playback Mode:)[Panasonic DVC USB-SERIAL Driver for Win XX(COM X)] (The numeral designation after “Win”will differ depending on the OS. The numeral after“COM” will differ depending on the operatingenvironment of your personal computer.)(When the Camcorder is in PC Mode:)[USB Mass Storage Device] or[Panasonic DV DISK Port Driver]Windows Me:(When the Camcorder is in PC Mode:)[USB Disk]≥Some Operating Systems, such as Windows98SE, may not show the icon indicating that youmay safely disconnect in task tray. (OS may beset not to show.) Make sure Camcorder’s CardAccess Lamp is off and disconnect the cable.Also, with Windows Me, the icon will not bedisplayed when in Tape Recording Mode orTape Playback Mode.CAUTION:If you disconnect the USB Cable while theCard Access Lamp is on, it may damage theCard data.
