Panasonic R410A Service Manual

Also see for R410A: Installation instructions Service manual Installation instructions Installation instructions

Contents

Panasonic R410A Service Manual Manual pdf 194 page image

7Item code Item Description10 Unit type Set when the indoor unit EEPROM memory is replaced during servicing.11 Indoor unit capacity12 System (outdoor unit)address These are not set at the time of shipping from the factory.These must be set after installation if automatic address setting is notperformed.13 Indoor unit address14 Group address17 Cooling intaketemperature shiftShifts the intake temperature during cooling and dry operation.(Enabled only when the body thermostat is used.)Increase this value when it is difficult to turn the thermostat ON.18 Automatic stop time afteroperation startThe time at which an indoor unit is automatically stopped after operationstarts can be set in increments of 5 minutes1b Forced thermostat ONtimeUse this setting to change the time for forced operation at installationor servicing from 5 minutes to 4 minutes.(Enabled only with PAC models.)1ETemperature shift forcooling/heating change in“auto heat/cool” mode“Auto heat/cool” selects the operating mode automatically based on thedifference between the room temperature and the temperature set onthe remote controller. This setting establishes a shift temperature forthe heating/cooling temperature setting relative to the remote controllertemperature setting.Cooling temperature settingHeating temperature settingRemote controller temperature settingShift temperatureShift temperature7-6. Detaild Setting ItemsCooling temperature settingRemote controller temperaturesettingHeating temperature settingShift temperatureShift temperature7-11