8Change the batteries when the display of the remote control gets weak or if it willnot work unless close to the receiver.(Alkaline batteries generally last about one year.)Reset holeCoverWhen changing batteries, always use two fresh batteries of the same make.If the remote control will not be used for a long period of time, remove the batteries.Please dispose of batteries appropriately.After changing the batteries, follow the procedures described below to reset thecurrent time.2 1,431. Remove the cover.2. Insert two AAA alkaline batteries.Put the batteries in with the polarity [+/–] as shown in the figure.3. Gently insert one end of an unfolded paper clip (or a similar object that canfit) into the Reset hole and press the Reset button inside the hole and thenput the cover back on.8-4. Installing Batteries3. Remove the other battery in the same way.1. Remove the cover.2. Press the battery toward the negative end and lift it out by its positive end.(As shown at right) How to remove batteriesNOTENOTE8-5. Setting the Current TimeAfter changing the batteries and pressing reset, be sure to reset the current time.(When reset is pressed, the current time reverts to [ ])1. Press for two seconds or more.2. Set the hour with / of the .If you press and hold the button, the time changes quickly.3. Set the minutes with / of the .If you press and hold the button, the time changes quickly.4. Pressing completes the time setting.While you are setting the current time, the time display flashes but the colon does not.If the buttons are not pressed for three minutes while setting the current time,it is set to the displayed time.When reset is pressed, the timer settings are deleted.NOTEOnce the clock displays starts blinking, the clock can be set.Dispose of the used batteries at the designated location in compliance with theapplicable local ordinances.8-5