Panasonic R410A Service Manual

Also see for R410A: Installation instructions Service manual Installation instructions Installation instructions

Contents

Panasonic R410A Service Manual Manual pdf 207 page image

88-8. Adjusting the Wind Direction8-9. Operating Multiple In/Outdoor Units Simultaneously (Group Control)Please face the flap (up-down winddirection plate) downwards. If it facesupwards, the warm air will not reachthe floor level.In the Heat ModePlease face the flap (up-down winddirection plate) upwards. If the platefaces downwards, condensationmay form and drip from aroundthe air outlet.In the Cool and Dry ModesIn the Fan Mode In All ModesDisplays with Swing StoppedInitial SettingInitial SettingInitial Setting Moves ConstantlyFan/Heat Modes Cool/Dry ModesNever try to manually move the flap (up-down wind direction plate) that is operated by the remote control.When the unit stops, the flap (up-down wind direction plate) automatically faces downwards.When the unit is in heating standby, the flap (up-down wind direction plate) faces upward.Also, bear in mind that the flap starts swinging after the heating standby mode is released, but the display on the remotecontrol indicates Auto Flap during standby heating as well.One remote control can operate up to eight indoor units.All the indoor units have identical settings.Set temperature sensing to the indoor unit (Main Sensor).CZ-RWSU2 / CZ-RWST2 /CZ-RWSL2 / CZ-RWSY2 / Indoor Unit (K1 type)Setting the Wind DirectionWhile the unit is operating, every time you press , the direction the flapfaces changes.Setting Flap to SwingIf you press to set the flap (up-down wind direction plate) in its mostdownward facing position, and then press again, is displayedand the flap swings automatically up and down.Stopping Flap SwingIf you press again while the flap is swinging, you can stop the flap fromswinging and set it in place as desired. Thereafter, if you press , you canset the wind direction starting from the most upward position.When the unit is in the Cool or Dry modes, the flap cannot stop facingdownwards. If you try to stop the flap from swinging while it is facingdownwards, it will continue moving until it is in the third position fromthe top.CZ-RWSC2The available functions differ depending on the indoor unit being used.The wind direction cannot be set via remote control for any models other than those noted below.For more information, please refer to the users’ manual that came with your indoor unit.Four-direction Ceiling Cassette Models, Bi-directional Ceiling Cassette Models,Unidirectional Cassette Models for High Ceilings, Ceiling Suspended Models, Wall ModelsGroup control works well for providing air conditioning to one,large room with more than one air conditioning units.Please refer to Setting the Wind Direction and Stopping Flap Swing.Indoor UnitIndoor UnitSignal LineReceiverWireless Remote Control8-8