Panasonic R410A Service Manual

Also see for R410A: Installation instructions Service manual Installation instructions Installation instructions

Contents

Panasonic R410A Service Manual Manual pdf 210 page image

8Use [Emergency Operation] in the following situations when there is an urgent need.When the remote control’s batteries have failed.When the remote control is broken.When the remote control is lost.*1 Figures: CZ-RWSU2, CZ-WRSY2 and CZ-RWST2 are of receivers (inside indoor unit),CZ-RWSL2 is of the operation panel (inside indoor unit) and Indoor Unit (K1 type) is of its front panel.CZ-RWSU2 / CZ-RWST2 / CZ-RWSY2 / Indoor Unit (K1 type)Start : press [Emergency Operation] of the receiver.If the indoor temperature is 24 °C or greater when the unit starts running, it will act as a cooler.If the indoor temperature is less than 24 °C when the unit starts running, it will act as a heater.Stop : press [Emergency Operation] of the receiver again.The Test Run/On and Test/On switches are for use when the unit is installed and test run. It is not for normal use.If the [Normal/Stop ALL] switch is on Stop ALL, the unit cannot receive signals from the remote control.CZ-RWSC2 / CZ-RWSL21. Press [Emergency Operation] of the receiver.If the indoor temperature is 24 °C or greater when the unit starts running, it will act as a cooler.If the indoor temperature is less than 24 °C when the unit starts running, it will act as a heater.2. If you press , the wind direction automatically oscillates up and down.Stop : press [Emergency Operation] of the receiver again.2 1CZ-RWSL2 CZ-RWSC2The Test Run/On and Test/On switches are for use when the unit is installed and test run. It is not for normal use.If the [Normal/Stop ALL] switch is on Stop ALL, the unit cannot receive signals from the remote control.NOTENOTE8-13. Emergency OperationStart/StopIndoor Unit (K1 type)CZ-RWST2Start/StopStart/StopCZ-RWSY2Start/StopCZ-RWSU2218-11