ENGLISHShootingE-1Shooting techniques for different targetsLow-angle shootingSet the Recording enable/disable switch to ONand use the START/STOP button on the handle tomake it easier to shoot from low angles.Set the Recording enable/disable switch to OFFto prevent inadvertent use of the START/STOPbutton on the handle when this function is notneeded.START/STOP buttonRecording enable/disable switchSelf-portrait shootingImages in the LCD when it is turned 180 degreesfor self-portrait shooting may appear unusual.You can make them appear better by reversingleft and right. Go to the setup menus, DISPLAYSETUP screen, SELF SHOOT, and selectMIRROR.Shooting in mirror mode has no effect on what youactually shoot and record.•Zebra patternPress the ZEBRA button in CAM mode to show thezebra pattern or marker on the screen so you cancheck the brightness of the subject.Parts that may be whited out through overexposure are shown as a zebra pattern.Very brightReflecting partsYou can remove most overexposed parts byadjusting the iris and shutter speed in the manualmode to remove the areas with zebra patterns.The display changes as follows each time youpress the ZEBRA button.ZEBRA 1 ZEBRA 2OFF MARKERBARSCH1 SELECTRESET/TC SET RECCH2 SELECTAUDIOINT(L)INPUT1INPUT2SHUTTER SPEES SELECTINT(R)INPUT2INPUT1MIC POWER+48VONOFFINPUT2ONOFFLCDZEBRAEVF DTLOISWFMCOUNTERIn the setup menus, DISPLAY SETUP screen,ZEBRA DETECT 1 and ZEBRA DETECT 2, set thebrightness for the zebra patterns. (Page 109)The zebra pattern you have set appears as apercentage on the display for about 2 seconds.MarkerIf you press the ZEBRA button again while thezebra pattern is being displayed, a marker appearsin the center of the display (if you have set thesetup menu, DISPLAY SETUP, MARKER to ON).The brightness of the areas near the screen centercan be checked as a percentage (0% to 99%).“99%” appears if the percentage is over 99.99%Image level detection areaImage levelMarkerThe normal display reappears if you press theZEBRA button again.••
