ENGLISHShootingE-53 Use the CH1 SELECT switch to selectthe input signal to be recorded to audiochannel 1.INT (L):Audio from the built-in microphone Lch isrecorded to audio channel 1.INPUT 1:Audio from a device connected to INPUT 1terminal is recorded to channel 1.INPUT :Audio from a device connected to INPUT 2terminal is recorded to channel 1.5 Use the CH SELECT switch to selectthe input signal to be recorded to audiochannel .INT (R):Audio from the built-in microphone Rch isrecorded to audio channel 2.INPUT :Audio from a device connected to INPUT 2terminal is recorded to channel 2.When inputting the microphone signal tochannels 1 and 2, connect the microphone toINPUT 2 and switch both CH1 SELECT andCH2 SELECT to INPUT 2.•Adjusting the recording levelAUDIO LEVEL knobUse the AUDIO LEVEL knob to adjust therecording level of the built-in microphone or ofaudio signals input through the INPUT 1/2 (XLR3-pin) terminal.To adjust the volume of the sound for monitoring.(Page 44)To adjust the recording level of the audio signals,turn the AUDIO LEVEL knob while referringto the audio level meter at the bottom left ofthe viewfinder and LCD monitor, regardless ofthe MIC ALC option setting (Page 106) on theRECORDING SETUP screen of the setting menu.When SYSTEM FREQ is set to 50 Hz1CH-18 dB -12 dB 0 dB2CH1CH2CHWhen SYSTEM FREQ is set to 59.9 Hz1CH-20 dB -12 dB 0 dB2CH1CH2CHThe CH1 and CH2 characters are highlighted(they will appear in black text) when INT MIC onthe AV IN/OUT SETUP screen is set to OFF.1CH2CH1CH2CHINT MIC ON INT MIC OFFCheck the recording level prior to shooting.The recording level is set higher than forPanasonic’s broadcast-use camera recorders(AJ series).••
