Panasonic UJ20 Series User Manual

Also see for UJ20 Series: How to use

Panasonic UJ20 Series User Manual Manual pdf 18 page image

Part names and functions10 Operation flowchartMode switching operation tableController panel display Mode name How to switch from AUTO modeAUTO AUTO mode Set by default when the power is turned onMNL ＊1 Manual (MNL) mode (EMISSION start) Hold down MODE switch.MNL flashing ＊2 External manual (MNL) mode (External start)Turn on the signal to INPUT terminal “MNL ON”on the rear panel. (Cannot be switched to anothermode while MNL is flashing.)ALL/MULTI Irradiation mode MNL mode + One press of MODE switchPULSE/STATUS Start signal mode MNL mode + Two presses of MODE switchX100hs LED replacement time setting mode MNL mode + Three presses of MODE switchW/cm2 UV intensity measurement/calibration mode MNL mode + Four presses of MODE switchTYPE Product type setting switch mode MNL mode + Five presses of MODE switchPROG Program setting mode MNL mode + Six presses of MODE switchPWR Power mode ON/OFF switch mode MNL mode + Seven presses of MODE switch*1 In manual mode (EMISSION start), it is possible to externally start irradiation by turning on the external signal to “MNL ON”.(MNL indicator will be turned on.)*2 In external manual mode (external start), it is possible to start irradiation by pressing EMISSION on the controller. (MNLindicator will flash.)Flowchart Power onAUTOMNLALL/MULTIPULSE/STATUSX100hrsW/cm2TYPEPROGPWRAUTO mode(Page 19)Mode nameManual (MNL) mode(Page 23)Irradiation mode(Page 26)Start signal mode(Page 27)LED replacementtime setting mode(Page 27)Product type settingswitch mode(Page 30)Program settingmode(Page 30)Power modeON/OFF switchmode(Page 32)External MNL ONExternal manual(MNL) mode(Page 26)UV intensitymeasurement/calibration mode(Page 28)