Panasonic WJ-FS316 Operating Instructions Manual

Also see for WJ-FS309: Operating instructions Operating instructions

219. ENCODEThis item lets you adjust parameters for playing backtapes that are recorded on a Panasonic system or a non-Panasonic system.1. Move the cursor to the ENCODE parameter.2. Select PANA or OTHERS by pressing the + or – button.The initial factory setting is PANA.PANA: Select this, if the tape was recorded on aPanasonic Multiplexer system.OTHERS: Select this for non-Panasonic system.9-1. SW INTERVALThis item lets you notify the Multiplexer of the field interval inwhich camera channels are switched on the recorded tape.1. Move the cursor to the SW INTERVAL parameter.2. Select 1, 2, or 4 by pressing the + or – button.The initial factory setting is 1.1: Select this, if the tape is recorded with field rate 1.2: Select this, if the tape is recorded with field rate 2.4: Select this, if the tape is recorded with field rate 4.9-2. NO. OF CAMSThis item lets you notify the Multiplexer of the highest chan-nel number recorded on a tape.1. Move the cursor to the NO. OF CAMS parameter.2. Select a camera channel between 1-16 (1-9 for WJ-FS309/FS409) by pressing the + or – button. The initialfactory setting is 16 (9 for WJ-FS309/FS409).Notes:• If PANA is selected, it is not necessary to set SWINTERVAL and NO. OF CAMS.• If OTHERS is selected, set the VCR's time mode to 2 Hor 6 H, not to T/L (Time Lapse).• If OTHERS is selected, tapes recorded with a randomorder of camera channels (e.g., recorded in ALM - PRI,ALM-ONLY or GROUP mode) will not be reproducedproperly.1. Set ENCODE to OTHERS.2. For SW INTERVAL, set the same value as for the VCRtime mode.3. For NO. OF CAMS, set the number of cameras record-ed on the tape.Notes:• Set SW INTERVAL to 1 for tapes recorded in 24H modeor longer.• Set SW INTERVAL as follows for tapes recorded in 2Hor 6H mode:1: Tapes recorded with field rate 12: Tapes recorded with field rate 23: Not available4: Tapes recorded with field rate 4• The display pattern of camera channels on the multi-screen may differ from the normal pattern as shownbelow. Camera 1 may be placed anywhere on the mul-tiscreen, followed by the other cameras in descendingnumerical order.SYSTEM SETUP 2/2ENCODE OTHERSSW INTERVAL 1NO. OF CAMS 9Playback of Tapes Recorded withOther Multiplexer SystemsThe following settings are necessary to play back videotapes recorded with multiplexer systems of other manufac-turers.1 34 5267 8 94 21 9387 6 5• To display a channel in SPOT mode, press the CAM-ERA SELECT button corresponding to the channel num-ber that is originally displayed in that screen segment.For example, press CAMERA SELECT button #1 to dis-play the channel 4 picture.• When playing back a tape recorded in an alarm prioritymode, camera channels are not displayed on the multi-screen in the recorded order.Example of display pattern forWJ-FS309/FS316/FS409/FS416Original