Panasonic WJ-GXE100 Operating Instructions Manual

Also see for WJ-GXE100: Specifications Installation guide

Contents

Panasonic WJ-GXE100 Operating Instructions Manual Manual pdf 41 page image

[Esc] buttonClick this button to return to the previous page.[All Reset] buttonDisplay the camera's setup menu, and then click the [All Reset] button after moving the cursor onto“CAMERA RESET” on the SPECIAL SETUP menu to reset to the default setting. Refer to the operatinginstructions of each camera for further information about the settings to be reset.[Reset/Special] buttonDisplay the setup menu of camera, move the cursor onto “SPECIAL”, and click this button to move to theSPECIAL SETUP menu.Move the cursor onto “REFRESH” on the SPECIAL SETUP menu, and click this button to refresh thecamera position.Item names and operations may differ depending on the cameras. Refer to the operating instructions ofthe camera for further information.[Focus] buttons• : Click this button to adjust the focus automatically.• : Click this button to adjust the focus to the “Near” side.• : Click this button to adjust the focus to the “Far” side.[Zoom] buttons• : Click this button to adjust the zoom ratio to the “Wide” side.• : Click this button to set the zoom ratio to x1.0.• : Click this button to adjust the zoom ratio to the “Tele” side.Control pad/buttons• Left-click on the control pad or buttons to adjust the horizontal/vertical position of the camera (panning/tilting).Panning/tilting speed will be faster if a clicked point gets farther from the center point of the control pad.It is also possible to pan/tilt the camera by dragging the mouse.Zoom and focus can be adjusted by right-clicking. When an upper/lower area of the control pad isright-clicked, the displayed image will be zoomed in/out on. When a left/right area is right-clicked, thefocus will be adjusted to the Near/Far side.Zoom can also be adjusted using the mouse wheel.8.5 Configure the settings relating to RS485 [RS485]Click the [RS485] tab on the “Image” page. (®page 21, page 23)The RS485 settings can be configured on this page to control the camera connected to the unit.Note• When cameras with different RS485 protocols (for example, cameras manufactured by Panasonic andPelco, Inc.) are in the same RS485 communication line, the cameras will not work correctly.• Select “4-line” or “2-line” according to the RS485 communication method specifications of theconnected cameras.• Refer to our website (http://panasonic.net/pss/security/support/info.html) for further information aboutthe control command (command table) of RS485.Operating Instructions 418 Configure the settings relating to images [Image]