Panasonic WJ-GXE100 Operating Instructions Manual

Also see for WJ-GXE100: Specifications Installation guide

Contents

Panasonic WJ-GXE100 Operating Instructions Manual Manual pdf 48 page image

[Post alarm]• Transmission intervalSelect the transmission interval for the alarm image transmission to the FTP server from the following.NTSC: 0.1fps/ 0.2fps/ 0.33fps/ 0.5fps/ 1fpsPAL: 0.08fps/ 0.17fps/ 0.28fps/ 0.42fps/ 1fps• Default: 1fps• Number of imagesSelect the number of images to be transmitted from the following.1pic/ 2pics/ 3pics/ 4pics/ 5pics/ 6pics/ 7pics/ 8pics/ 9pics/ 10pics/ 20pics/ 30pics/ 50pics/ 100pics/ 200pics/300pics/ 500pics/ 1000pics/ 2000pics/ 3000pics• Default: 100pics• Recording durationApproximate time to be taken to save the set “Number of images” with the set “Transmission interval” willbe displayed.[Image capture size]Select the capture size of images to be transmitted to the FTP server or of an image to be attached to thealarm E-mail.Picture (Camera) mode VGA [4:3] QVGA/VGAPicture (Camera) mode VGA [16:9] 320x180/640x360• Default: VGA[Image compression rate upon alarm detection]Select “On” or “Off” to determine whether or not to change the image quality of “Quality1” (®page 33) uponalarm detection.• On: Images will be transmitted with the image quality selected for “Image quality upon alarm detection”.• Off: Does not change the image quality upon alarm detection.• Default: Off[Image quality upon alarm detection]Image quality can be changed upon an alarm occurrence. Select the image quality from the following.0 Super fine/ 1 Fine/ 2/ 3/ 4/ 5 Normal/ 6/ 7/ 8/ 9 Low• Default: 5 Normal10.3 Configure the VMD settings [VMD area]Click the [VMD area] tab on the “Alarm” page. (®page 21, page 23)The VMD areas can be set on this page.Up to 4 areas can be set. When motion is detected in the set area, it will be regarded as an alarm.IMPORTANT• The alarm occurrence indication button (®page 9) will be displayed when motion is detected by theVMD function.• The alarm occurrence indication button will be displayed when receiving a command alarm or videoloss alarm.• Depending on the network environment, notification may be delayed even when “Real time” is selectedfor “Alarm status update mode” on the [Basic] tab of the “Basic” page (®page 27).48 Operating Instructions10 Configure the alarm settings [Alarm]