58Configure the alarm action settings [Event Setup]Configure the settings relating to the alarm action that is to be taken at an event occurrence.Refer to page 27 for further information about the event type and the alarm action.q Configure the common settings for the alarm recording [Common Setup]Configure the common settings relating to the alarm action that is to be taken when an event (terminal alarm, VMD alarm, com-mand alarm) occurred. Alarm BuzzSelect "On" or "Off" to determine whether or not to sound thebuzzer at an event occurrence. The selected duration for"Alarm Duration" of "Alarm Rec. Setup" ( page 59) will beapplied as the sounding duration of the buzzer.On: Sound the buzzerOff: Do not sound the buzzerDefault: On Alarm SpotSelect "On" or "Off" to determine whether or not to displayimages from the camera that is selected for "Alarm SpotCamera No." of "Alarm Rec. Setup (Advance)" ( page 59)on a single screen at an event occurrence.On: Display images from the selected camera.Off: Do not display images from the selected camera.Default: OnNote:The screen that was displayed immediately before anevent resumes after the event is finished. Pre Alarm RecordingSelect "On" or "Off" to determine whether or not to startrecording from the specified seconds before an eventoccurrence (pre-alarm recording).On: Start the pre-alarm recording.Off: Do not start the pre-alarm recording.Default: OffNotes:• Maximum recording duration of the pre-alarm recordingis approximately 5 seconds. Recording duration of thepre-alarm recording varies depending on the followingsettings.• I Frame Interval• Capture Resolution• Rec. Quality• Rec. Frame Rate• Audio is not recorded during pre-alarm recording.Common SetupAlarm Buzz OnAlarm Spot OnPre Alarm Recording OffOK CancelEvent SetupCommon SetupAlarm Rec. Setupq w