110■ Tour SequenceThe following functions are available if a tour sequence hasbeen previously configured through SETUP MENU or WJ-SX150 Administrator Console. Any tour sequence can beassigned to any monitors.1. Select the desired monitor. (Refer to p. 109 MonitorSelection.)2. To select the desired tour sequence number, press thenumeric buttons.3. Press the SEQ button to run the tour sequence in theforward direction on the active monitor.4. Press the SEQ PAUSE button to pause a tour sequenceon the active monitor.A series of camera picture appear in pause on the mon-itor screen for the specified dwell time.5. Press the SEQ PAUSE button again to restart a toursequence forward from the next step that was previous-ly paused by pressing the SEQ PAUSE button.6. Press the SHIFT button, and then press the + button tomove the sequence one frame to the next step from thestep that was previously paused by pressing thePAUSE button.Press the SHIFT button, and then press the - button tomove the sequence one frame to the previous step fromthe step that was previously paused by pressing thePAUSE button.7. Select a camera (refer to the system controller's operat-ing instructions) to stop the sequence. The monitor willreturn to the spot mode.■ Group SequenceThe following function is available only if a group sequencehas been previously established in WJ-SX150 AdministratorConsole. The group sequence has ID numbers. Group 1 is17, Group 2 is 18, Group 3 is 19, and Group 4 is 20.As described earlier, a group sequence determines theassignment of monitors and cameras. Therefore, monitorselection is not required.1. Press the numeric buttons to select a desired groupsequence ID number, then press the SEQ button.2. Press the SEQ button to run a group sequence forwardon the assigned monitors.5. Press the SEQ PAUSE button again to restart a toursequence forward from the next step that was previous-ly paused by pressing the SEQ PAUSE button.6. Press the SHIFT button, and then press the + button tomove the sequence one frame to the next step from thestep that was previously paused by pressing thePAUSE button.Press the SHIFT button, and then press the - button tomove the sequence one frame to the previous step fromthe step that was previously paused by pressing thePAUSE button.7. Select a camera (refer to the system controller's operat-ing instructions) to stop the sequence. The monitor willreturn to the spot mode.RUNNING SEQUENCE