Panasonic WJ-SX150 Operating Instructions Manual

Also see for WJSX150 - SWITCHER - ADDENDUM: Addendum Addendum manual Operating instructions

Contents

Panasonic WJ-SX150 Operating Instructions Manual Manual pdf 72 page image

74• Alarm Reset TimeSelect the time to reset the alarm input.The selectable time: OFF (not resetting the alarm), 10, 20,30, 40, 50, 60, 120 or 180 (seconds)The factory default setting is 30 sec.(Save Exit) buttonSaves the configuration and closes the Alarm Mode win-dow.(Cancel Exit) buttonCancels the configuration and closes the Alarm Mode win-dow.■ Alarm EventThis window configures the details of operation parameterswhen an alarm signal is input: the monitor and mode to dis-play the alarm image, and the preset position of the cam-era. Up to 16 alarm inputs are configurable.● How to DisplayTo display this window, click on the (Alarm Event) but-ton in the main window (p. 65).● ParametersMon (Monitor)Select the monitor to display the alarm image.Spot/TourSelect the spot camera number or the tour sequence num-ber.Cam 1 to 16: To display a spot picture, select a cameranumber.Tour 1 to 16: To execute a tour sequence, select a tournumber.Pre (Preset Position Number)Select the preset position of the camera when selecting thespot camera number in Spot/Tour. Position 1 to 64 is selec-table for Pre. When the camera is not equipped with thepreset position function, select "--".Notes:• If having selected a tour sequence for a monitor, anoth-er tour number or spot camera will not be availablewhen selecting the monitor for another alarm event.That will result in an error.• In the factory default setting, Tour 1 to 4 is selectable.To select Tour 5 to 16, you need to configure the toursequences in the Tour Sequence window. (Refer to p.68.)(Save Exit) buttonSaves the configuration and closes the Alarm Event win-dow.(Cancel Exit) buttonCancels the configuration and closes the Alarm Event win-dow.■ Alarm PortThis window configures the parameters of alarm inputs.● How to DisplayTo display this window, click on the (Alarm Port) but-ton in the main window (p. 65).● Parameters• Alarm Port GroupSelect the desired alarm input parameter in each alarmport's drop-down menu.N.O. : Normally OpenN.C. : Normally Close• Time Adjust BoxSelect the alarm port to assign to the time adjustment.When not assign any port to time adjustment, select None.(Save Exit) buttonSaves the configuration and closes the Alarm Input window.(Cancel Exit) buttonCancels the configuration and closes the Alarm Input win-dow.