Panasonic WJ-SX150 Operating Instructions Manual

Also see for WJSX150 - SWITCHER - ADDENDUM: Addendum Addendum manual Operating instructions

Contents

Panasonic WJ-SX150 Operating Instructions Manual Manual pdf 79 page image

81■ Data PortThis window configures the parameters of each data port(RS485, DATA 1 to 4 and DATA HDR port): the protocol, thebaud rate (communication speed), and the connectedcameras.● How to DisplayTo display this window, click on the (Data Port) buttonin the main window (p. 65).● Parameters• RS-485 Port GroupProtocol: Select RS485 when an RS-485 camera isconnected to the data port.Select CU360C when the system controller is con-nected to the data port.Select PSD when the system controller is connectedto the DATA 4 port via the PS·Data protocol.PS·Data mode will appear in the window.Note: The baud rate of DATA HDR is the same asthat of PSD. When you select PSD for DATA 4,DATA HDR and its baud rate are displayed ingray and not configurable. When you selectCU360C for DATA 4, DATA HDR and its baudrate are configurable.Baud Rate: Select the desired baud rate (communica-tion speed). 4800, 9600 or 19200 bps is selectable.RS485 Camera Daisy (RS-485 Camera Daisy): Selectthe number(s) of the camera(s) connected to theRS-485 daisy chain.Data 1 to 3 are connectable to either of camerasand system controllers.When connecting cameras to these ports, select theconnected camera number(s).PS·Data mode: This stands for the PS·Data parametersof the DATA 4 port.Logout Time: Select the desired operable timebefore logout. OFF,10, 20, 30, 60, 90 or 120 secis available.The factory default setting is 30 sec.Alarm Data: Select the desired time to accept analarm input signal. OFF, 0, 1 or 5 sec is avail-able.The factory default setting is 1 sec.Wait Time: Select the desired wait time to transmitan alarm output signal. OFF, 100msec, 200msec, 400m sec or 1 sec is available.The factory default setting is OFF.Group Address: This parameter is only for confir-mation. Leave as it is.• Fixed Common Parameter GroupThe data bit (8 bit), parity (none), and stop bit (1 bit) aredisplayed. These parameters are fixed.(Save Exit) buttonSaves the configuration and closes the Data Port window.(Cancel Exit) buttonCancels the configuration and closes the Data Port window.