■ Alarm ModeThis window configures the operation parameters when analarm signal is input: an alarm mode, auto reset time andalarm input.● How to DisplayTo display this window, click on the (Alarm Mode) but-ton in the main window (p. 65).● Parameters• Alarm ModeChecking on the box of the desired alarm mode.OFF: The system operation does not change into anyother mode.Sequence Mode: Camera images are displayed on themonitor in either the spot mode or tour sequence.When more than one alarm are input, the imageassociated to each alarm is displayed in thesequence mode.Note: Click on the Dwell drop-down menu to selectthe dwell time.Hold Mode: Camera images are displayed on the mon-itor in either the spot mode or tour sequence. Evenmore than one alarm are input, the image associat-ed to the initial alarm is continuously displayed.Notes:• The alarm mode is activated when alarm input signalsare assigned to the same monitor through 420 ALARMEVENT or the Alarm Event (refer to p. 56 or p. 74) win-dow.• While alarm is activated, you cannot operate the func-tions related to the multiplexer board.• Alarm Input GroupSelect the alarm input to be accepted. Multiple Selection isavailable.CameraThis stands for that an alarm input is accepted via theCAMERA IN connectors or the RS-485 ports.ON: The alarm-associated sequence/spot image is dis-played on a monitor, and alarm recording will start(if a recorder is connected to the unit).72(Save Exit) button:Saves the configuration and closes the Daylight SavingTime window.(Cancel Exit) button:Cancels the configuration and closes the Daylight SavingTime window.
