Panasonic WV-CS850 Operating Instructions Manual

Contents

40Important Notices:• The object of motion detection should meet the following conditions.1) It should be larger than 1/48 of the size of the picture screen.2) The contrast ratio (at max. detection level) between the object and the background picture on thescreen should be more than 5 %.3) The time it takes the object to move from one end of the screen to the other should be more than0.1 seconds.• Also under the following conditions, mask or adjust the detection level to prevent malfunction.1) When leaves or curtains etc, are swayed by the wind.2) When a noisy picture exists such as under low light condition.3) When the object is subjected to illumination by lighting equipment that constantly turns on andoff.• The alarm signal will take about 0.2 second to reach the alarm terminal of the VTR, after the cameradetects the object.Because the alarm signal is multiplexed on the video signal it may be mistakenly interpreted by othervideo equipment as a time code signal. Therefore, when this camera is not used in a PanasonicIntelligent CCTV System, select OFF to prevent the above from occurring.10. Auto Focus Setting (AF MODE)1. Move the cursor to AF MODE, then select a mode from amongthe following by moving the joystick to the left or right. S, M and Lstand for Small, Middle and Large areas in the centre of a scenethat are used for sensing sharpness in auto-focusing.** SET UP **CAMERA IDALC/MANUALSHUTTERAGCSENS UPSYNCWHITE BALMOTION DETAF MODERET SPECIAL2OFFALCOFFONOFFINTATWONMANUAL SCamera setting menuAUTO S AUTO M AUTO LMANUAL S MANUAL M MANUAL LMANUAL S, M, L: Brings the camera into focus when the AF keyon the controller is pressed.AUTO S, M, L: Brings the camera into focus after manual pan, tiltor zoom. These may be selected in the same way as select-ing MANUAL by pressing the AF key on the controller.2. To confirm auto-focus operation, press CAM (SET) key while thecursor is at AF MODE.Notes:• When the electronic sensitivity enhancement (SENS UP) is active,this function is automatically set to MANUAL.• The auto focus lens may not function properly in AUTO under thefollowing conditions.1. Dirt or water on window glass.The auto focus may focus on the dirt or water.2. Low lighting/illumination or zone marker is blinking.3. Bright objects or high intensity objects.4. Single colour with un figured object such as white wall or finefelt.5. No centre objects, sloping objects.6. Far and near objects on the screen.Intelligent Security & Fire