Paradyne 3150 Operator's Manual

Also see for 3151: Quick installation Release note Information guide Quick reference Quick reference

Contents

Paradyne 3150 Operator's Manual Manual pdf 34 page image

ACCULINK 315x CSU3-12 February 1998 3150-A2-GB21-80The example shown below assumes that the COM portis being used as the link to the SNMP or Telnet system.To select the COM port as the SNMP or Telnet link,1. From the top-level menu screen, select Cnfig.2. Select the configuration option set to be copiedinto the Edit area by using the appropriateFunction key. Use the scroll keys, if necessary.3. Select Edit.4. Select User.F1Edit:NET Gen UserF2 F35. Press F1 (Next) until the Com Use configurationoption appears.6. Select Mgmt to configure the COM port as theSNMP or Telnet link.F1Com Use:Next Mgmt ASCIIF2 F3Setting the IP AddressThe IP address is the address used by the SNMP orTelnet system to access the CSU (see Appendix F, IPNetwork Addressing Scenarios). For CSUs using PPP, theIP address can be negotiated if the network device (e.g.,router or SNMP manager) supports such negotiation. TheIP address is composed of four fields with three digits perfield (xxx.xxx.xxx.xxx).The IP address is set for the MODEM port, the COMport, or the AUX port (with LAN Adapter or daisy chain),depending on which one has been chosen as the SNMP orTelnet communication link. The example below assumesthat an IP address of 010.155.111.222 is being set for theCOM port. You can use the same principles to assign anyvalue (between 000 and 255 for each digit field) to otherports.To assign an IP address to the COM port,1. From the top-level menu screen, select Cnfig.2. Select the configuration option set to be copiedinto the Edit area by using the appropriateFunction key. Use the scroll keys, if necessary.3. Select Edit.4. From the Edit screen, press the key until theMgmt selection appears on the screen.5. Select Mgmt.F1Edit:User Alarm MgmtF2 F36. From the Mgmt Config screen, select Gen.F1Mgmt Config:Gen TrapF2 F3