Paradyne 8310 MVLt User Manual

Also see for HOTWIRE DSLAM: User guide Network configuration guide

Contents

8310 MVL and 8510 RADSL Card Configuration4-12 8000-A2-GB26-10January 1999Table 4-4. Bridge Options (2 of 3)Client VNID A-E-DGives the user the ability to configure static clients on VNIDs. Up to 32 entries per port(static users, DHCP users, or subnets) are allowed. Multiple screens are required tocompletely configure the port.For a list of VNID, press Ctrl-v.DSL Port # – Enter the DSL port number 1–4 (Default = 1).Item – Enter 0 to add a new client or enter an existing entry number to edit this entry.IP Address – For single users, enter the client IP address innnn.nnn.nnn.nnn format(Default = none). There must be an entry in this field. Typically, all IP addresses in thesame VNID would be on the same subnet.NOTE: For additional information, refer toConfiguring Subnet Masks in Chapter 3,Configuring the Hotwire DSLAM.Subnet Mask – For multiple users with IP addresses in the same subnet, enter both theIP address and the subnet mask innnn.nnn.nnn.nnn format.CAUTION: The same subnet cannot be assigned to multiple ports. An errormessage will appear if the IP address of the next hop router is not in thesame subnet as the client IP address. Geographically dispersed clientsare supported through static host-specific entries only.NHR – Enter the IP address of the next hop router innnn.nnn.nnn.nnn format, ifdifferent than the default for the VNID (Default = none).VNID – VNID ID between 2–4094 (This field is read-only.)Type – S = Static or D = Dynamic (This field is read-only.)NOTE: If a DHCP response cannot be added to the host table because it alreadyhas 32 entries, and if IP scoping/filtering has been enabled on the CardVNID screen (A-E-B), any subsequent upstream packets from that host aredropped.