Download CodeA-2 8000-A2-GB26-10January 1999Download CodeWhen you are attempting to download to the DSL cards, refer to Table 5-1, CardStatus Options, in Chapter 5,8310 MVL and 8510 RADSL Card Configuration. Ingeneral, the following describes what to expect when you have initiated adownload from the configuration menu.From the DSL Configuration Main Menu, follow the menu selection sequence:Configuration →Card Status →Download Code (A-A-F).This brings you to the Download Code submenu. Select Download Code (A).NOTE:To download code to the Service Node(s), you must use the MCC downloadmenu. For information on this and other methods used to download firmwareto the DSL and MVL cards, seeConfiguration Options in theHotwireManagement Communications Controller (MCC) Card, IP Conservative,User’s Guide.Download Only System: Automatic Immediate ApplyBefore initiating a download, go to the MCC card and verify that you can Ping theTFTP server. If you cannot, do not proceed with the download. Also, make certainthat the files that you are going to download from exist in the system.In order for the system to become fully functional again, you must start theDownload Code file transfer procedure. Enter the image file name and the TFTPService IP address. Select Yes to begin the file transfer. When the file transferhas successfully completed, the system will automatically restart and becomefully functional with the newly acquired firmware.