ACCULINK 317x E1 DSU/CSU3-10 December 1996 3170-A2-GB20-20Displaying LED ConditionsThe same conditions monitored by the front panelLEDs can also be monitored by the LED command. Thiscommand is most useful when the E1 DSU/CSU is beingaccessed remotely (see Appendix G, Front PanelEmulation). When using Front Panel Emulation, no LEDsare shown on the PC’s screen; you must use the Statcommand procedure described below to get LEDinformation.To display LED conditions on the front panel screen,1. Press F1 to select Stat from the top-level menuscreen.F1DS U E 1 CEPTStat Test CnfigF2 F32. From the Status screen, press the key todisplay the LED selection.F1Status:DevHS STest PerfF2 F33. Select LED from the Status screen.F1Status:Perf TStat LEDF2 F34. From the Select LEDs screen, press the Functionkey that corresponds to E1 or the port for whichyou want to display LEDs. Use the scroll keys, ifnecessary.F1Select LEDs:E1 Prt1 Prt2F2 F3If you chose E1, the LED Display screen lists theLED signals, two at a time, on the second line. Avertical bar at the left of the LED name indicatesthe condition is ON, while an underscore indicatesthe condition is Off.F1LED Display:_Test _NetSigF2 F3If you chose a port, the Port n LEDs screen liststhe LED signals, two at a time, on the second line.A vertical bar at the left of the LED nameindicates the condition is ON, while an underscoreindicates the condition is Off.F1Portn LEDs:_DTR _TXDF2 F35. Use the and keys to scroll LED namesonto the screen.
