Parameter Reference D-100AC30V series Variable Speed DriveSoft MenusParameters::Device Manager::Soft MenusPNO Parameter Descriptions0908 Control Screen ModeDefines the operation of the Control Screen0 DISABLED1 AUTO2 CUSTOMWhen set to DISABLED, the Control Screen menu is hidden.When set to AUTO, the contents of the Control Screen menu depends on the sequencing mode of the drive, (local, remote orcommunications).When set to CUSTOM, the contents of the Control Screen may be defined by writing parameter numbers to the elements of the 1352Control Screen array. Note that the contents of the 1352 Control Screen array are not saved in non-volatile memory, so the valuesneed to be initialised following a power-on reset.1352 Control ScreenAn array of PNOs that identifies the parameters to be shown in the Control Screen. The contents of this screen are set automaticallyby the AC30 firmware when the control mode is changed.1188 FavouritesAn array of PNOs that identifies the parameters to be shown in the Favourites menu1311 SetupAn array of PNOs that identifies the parameters to be shown in the Setup menu1270 MonitorAn array of PNOs that identifies the parameters to be shown in the Monitor menuFunctional DescriptionThe Soft Menus group of parameters are used to populate the associated menus depending on the associated application, (Control Screen,Setup and Monitor) or the requirements of the location, (Favourites). The contents of the Setup and Monitor menus may only be set by theapplication itself. The contents of the Favourites menu may be set by writing to the parameters in the Favourites array. Alternatively parametersmay be added to or removed from the Favourites menu by use of the GKP. Navigate to the parameter of interest and hold the OK key until theattributes screen is shown. If the parameter is not already in the Favourites menu a pressing the Soft Right key adds the parameter to Favourites.This operation is indicated by the icon . Similarly, to remove a parameter from Favourites, navigate to the parameter in the Favouritesmenu then press OK until the parameter attributes are shown. Remove the parameter from Favourites by pressing the Soft Right key. Thisoperation is indicated by the icon .
