2–Getting StartedHardware and Software Setup2-12 ISR654608-00 CHardware and Software SetupFollow the procedures and guidelines in this section for setting up your hardwareand software.Hardware SetupFor information on installing your iSR6200, refer to the iSR6200 IntelligentStorage Router Installation Guide.To set up the hardware for DMS:1. To manage the iSR6200, install the SANsurfer iSCSI/FC Router Managerutility on any computer running Windows 2003, Windows 2008, or WindowsXP. The iSR6200 must be accessible over the network connection from themachine on which SANsurfer iSCSI/FC Router Manager is installed.2. Set up the iSR6200 management port IP address. For details, refer to theiSR6200 Intelligent Storage Router Quick Start Guide.3. Connect the storage array (source and destination) controller ports to aFibre Channel switch. For details on various topology configurations, see“Data Migration Configuration” on page 2-3.4. Connect the Fibre Channel ports of the iSR6200 to the Fibre Channelswitches where the array controller ports are connected. For details onvarious topology configurations, see “Data Migration Configuration” onpage 2-3.Software SetupSoftware setup for DMS includes the following: Zoning: Perform zoning on the Fibre Channel switches such that arraycontroller ports are visible to the iSR6200, and the array is able to see virtualports created by iSR6200 Fibre Channel ports and can present LUNs to theiSR6200. LUN Presentation: Ensure the appropriate data LUNs are presented fromthe storage arrays to the iSR6200. Multipathing: For online data migration, ensure that the latest multipathingsoftware is installed on the host server, and that both router blades are usingthe same firmware version.High Availability ConsiderationsFor HA configurations where multiple Fibre Channel ports (from one or bothblades) of the router are visible on the source or destination array, ensure that allWWPNs from the same virtual port group across both blades of the iSR6200 areconfigured under a single host or host group entity in the array managementsoftware.
