501510 Rev. S RLS Expansions 9-9Access PanelRear of LibraryStorage Array removedfrom the Library.Figure 9-6 Access Panel on Rear of the Library and Storage Array Removed from Library9. If the RLS is not rack-mounted, carefully turn it on its left side (as seen from thefront) so that the Storage Array mounting screws located on the bottom of the li-brary can be accessed.10. There are five Storage Array mounting screws located on the bottom of the chas-sis. Using a No. 2 Phillips screwdriver, remove the screws as shown in Figure9-5. If the RLS is on its side, hold the Storage Array Assembly in place with onehand while removing the final screw.11. Set the RLS chassis upright. Grasp the front and the rear of the Storage ArrayAssembly and gently lift it up and then out through the rear of the chassis. SeeFigure 9-6.9.2.5 Style B Chassis Storage Array Expansion Kit InstallationThis procedure assumes that the 4445 Storage Array was removed in Section 9.2.4.1. If the RLS is not rack-mounted, carefully turn it on its left side (as seen from thefront) so that the Storage Array mounting screws located on the bottom of the li-brary can be accessed.
