501510 Rev. S Troubleshooting 6-36.2.1 BCR Failed (BCR is the Barcode Reader)During POST (Power On Self Test) the Barcode Reader failed, is installed improperly,or is configured improperly. If there is no Barcode Reader, set the BCR value to Nonein the Configuration\Advanced\Changer\Mechanics menu.6.2.2 BCR Misconfigured (BCR is the Barcode Reader)During POST (Power On Self Test) the system detected that the Barcode Reader isconfigured improperly.6.2.3 Calibration Req’dA change has been made to the RLS configuration that disabled the library pendingcalibration. Re-calibration is required!6.2.4 Not ConfiguredThe library is not configured. Configure the library as described in the Installationand Operation Manual (Qualstar document number 501500).6.2.5 Carousel Failed, Carousel JammedThe carousel mechanism failed to move successfully or is jammed. Open the Top Cov-er (see Section 7.6) and check that all the magazines and cartridges on the carouselare properly seated. Verify the drive belt is in place and free of slack.6.2.6 Array Failed, Array JammedThe Storage Array mechanism has failed to move successfully. Open the Top Cover(see Section 7.6) and check that all the magazines and cartridges on the Storage Ar-ray are properly seated.6.2.7 Gripper Homing FailedDuring POST (Power On Self Test), the Gripper Home Sensor did not indicate thegripping mechanism reached its home position. This could be caused by a failed infra-red emitter or detector, requiring replacing the Carriage Assembly. A large piece ofdust or an errant barcode label in the Handler could also cause this failure.6.2.8 X Failed to HomeDuring POST (Power On Self Test) the RLS did not detect that the Handler success-fully reach its home position at the right side of the Carriage Assembly. Check thatthere are no loose magazines or cartridges in the library. Check that the Tape Drivesare properly seated and their locking levers are fastened in the up position. Check
