Quantum Scalar i40 User Manual

Also see for Scalar i40: Quick start guide User guide Quick start guide User guide Installation

Contents

Quantum Scalar i40 User Manual Manual pdf 199 page image

Chapter 8: Installing, Removing, and Replacing ComponentsConnecting Library CablesQuantum Scalar i40 and Scalar i80 User’s Guide 173Connecting Library CablesConnect the cords and cables as follows (see Figure 31 on page 174). Itis recommended that you leave some slack in the cables to allow you toperform certain replacement procedures in the future.1 Connect the tape drive cables from the tape drives to the host.Caution: Use care when handling the fibre optic cables. Do notcrimp or bend the cables. Do not exceed the bendradius specified by the manufacturer.2 Connect an Ethernet cable (not supplied with your library) into theLEFT port on the system control board (SCB). The right SCB port isfor service use only; do not use. Connect the other end of theEthernet cable into a live Ethernet jack connected to your network.3 Connect the power supply cord into the power supply connector.Plug the other end of the cord into a grounded AC outlet.