Chapter 4: Configuring the LibrarySetting the Date, Time, and Time ZoneQuantum Scalar i40 and Scalar i80 User’s Guide 49libraries support SNMP by publishing a MIB that can be queried toobtain the status of the library and many of its individual components.Administrative users can download the SNMP MIB from the library. TheMIB can then be installed on an SNMP external managementapplication.For more information about the library MIB, see theScalar i40 andScalar i80 Basic SNMP Reference Guide (6-66773-xx) or contactQuantum Support.For information on integrating MIBs with an SNMP managementapplication, contact your network management application vendor.Web Client1 Select Tools > Download SNMP MIB.2 Save the file to a known location.Setting the Date, Time, and Time ZoneYou can either set the library date, time, and time zone settingsmanually or configure the Network Time Protocol (NTP). NTP allows youto synchronize the library date and time with other components in yourIT infrastructure.If NTP is enabled, the IP address of at least one NTP server must beconfigured. Contact your network administrator for NTP server IPaddress information.You can configure the date and time on both the operator panel andthe Web client. You can view the time zone on the operator panel, butmust use the Web client to change it. You can only configure NTPsettings on the Web client.Note: The following operations should not be performedconcurrently by multiple administrative users logged in fromdifferent locations. You can access the appropriate screens, butyou cannot apply changes while another administrative user isperforming the same operation.
