6-4 Advanced adjustmentsRibbon Wrinkling AdjustmentsThe QLS-4100 Xe features an automatic ribbon tensioning mechanism toensure consistent tension from a full to empty ribbon supply roll.The ribbon width should be matched to the label or tag width. Make surethat the ribbon is not more than ¼ inch wider than the label because it maycause the ribbon to wrinkle.The ribbon should also not be narrower than the label or tag because it maycause unnecessary wear to the printhead.Normally, a manual ribbon tension adjustment is not required. However, ifyou notice film wrinkling or one of the colors smudging, you can adjust thetension to alleviate these conditions.• If film is wrinkling on a station, turn the knob on the ribbon supplymandrel clockwise to increase the tension.• If ink is smudging at a station, turn the knob on the ribbon supplymandrel counterclockwise to decrease the tension.
