4-30 Keypad controls and menusCutter BaselineThis function is used to synchronize printing when using multiplecutters. If you are sending the same image file to two or more printers/cuttersand notice that the cutter cuts in different vertical locations, you can use thisfunction to move the vertical baseline of a cutter.Cutter baseline adjusts the position of the cut line with respect to Cut Offset.Possible values range from -120 to +120 dots.To adjust the cutter baseline:1 If the printer is in a Ready state, press the PRINT/PAUSE key to pausethe printer.2 Press the NEXT or PREVIOUS key until the Cal & Setup menu isdisplayed. Then press the SELECT key.3 Press the NEXT or PREVIOUS key until the Cutter Baseline menu isdisplayed.4 Press the + or – key until the desired baseline setting is displayed.Baseline settings range from -120 through +120 dots. Negative valuesmove the cut line toward the bottom of the tag. Positive values move thecut line toward the top of the tag.5 Press the SELECT key to confirm the baseline.Cutter BaselineBaseline = 0Pause: Cal & SetupPress SELECT
