QLS-4100 Xe 8-19Print & Peel Adjustment OptionsThis section describes menu options associated with Print & Peel adjustment.Form Stop AdjustWhen labels are printed, they are advanced from the front of the printer forremoval. In Print & Peel single label mode, you can increase/decrease thedistance labels are advanced after printing.Note: This option is available only in Print & Peel single label mode.To adjust the form stop position:1 If the printer is in a Ready state, proceed to the next step.If the printer is in a Pause state, press the NEXT or PREVIOUS key untilthe Adjust menu is displayed. Then press the SELECT key.2 Press the NEXT or PREVIOUS key until the Form Stop Adjust menu isdisplayed.3 Press the + or – key until the desired form stop adjust setting isdisplayed.Form stop adjust settings range from -300 dots to +14400 dots(-1 inch to +48.0 inches) (-25.4 mm to 1219.2 mm).4 Press the SELECT key to confirm.Form Stop Adjust+0 (+0.0 mm)Pause: AdjustPress SELECT
