53ReferenceTroubleshootingTroubles sometimes are caused by simple “faults” that you can correct without thehelp of a service technician. If you experience any difficulty with your TV, check a fewbasic remedies before calling your service technician.TV will not turn on• Check to make sure it is plugged in.• Check the wall receptacle (or extension cord) to make sure it is “live” byplugging in something else.• Maybe batteries in remote control are “dead.”• Maybe remote control is not aimed at remote sensor.• The front panel controls may be locked (disabled). Use the remote control tounlock the front panel controls by selecting the Front Panel Block in the ParentalControls menu and choosing Unblock.Controls don’t work• If using remote control, make sure remote is in TV mode by first pressing TVbutton.• The front panel MENU button may be disabled. Use the remote control to turnoff channel blocking. Select Channel Block in the Parental Controls menu andchoose Off.• Try unplugging set for two minutes and then plug it back in and turn it on again.Problems with remote• Maybe something is between the remote and the remote sensor.• Maybe the remote is not aimed directly at the component (TV or VCR) you aretrying to control.• Maybe remote is not in TV Mode. Press the TV button so remote will control TV.• Maybe batteries in remote are weak, dead or installed incorrectly. Try replacingbatteries. (Note, if you remove the batteries, you may have to reprogram theremote to control other components.)• Remove batteries and hold number 1 for at least 60 seconds to drain themicroprocessor inside the remote. Release number 1, replace the batteries, and(if necessary) reprogram the remote.Guide comes on when I turn on TV• The Guide automatically comes up when you use the TV button on the remote toturn on the TV. You can turn off this feature by selecting GUIDE Plus+ Menu fromthe Main Menu, then select Setup, then select Options and then select Off.Turns off while playing• Schedule off function may have been activated.• Electronic protection circuit may have been activated because of a power surge.Wait 30 seconds and then turn on again. If this happens frequently, the voltagein your house may be abnormally high or low.• Unplug. Wait five minutes. Plug in again.