RCA RCU1010RF Quick Start Manual

Also see for RCU1010RF: Quick start guide User guide

Contents

RCA RCU1010RF Quick Start Manual Manual pdf 2 page image

1. Turn the unit over, push on the tab and slidethe cover down.2. Insert the batteries, matching the batteries tothe (+) and (-) marks inside the battery case.3. Slide the battery cover back into place.Follow these few simple steps to set up the Remote Sender Cone.1. Place the Remote Sender Cone in the room where the components to be controlled are located.2. Plug the Remote Sender Cone into a standard electrical outlet.3. Point the front of the unit (logo side) facing the component(s) you wish to operate.4. Extend the antenna for best performance.5. Be sure that the Remote Sender Cone is positioned within 20 feet (6.096 meters) of the components you wishto control. The remote control unit will operate within 100 feet* (30.48 meters) of the Remote Sender Cone.Note: The Remote Sender Cone must be placed within line of sight of components to be controlled.Remote Sender Cone SetupWhen trying to control multiple components behind a closed door (entertainmentcenter), experiment with the placement of the Remote Sender Cone. In most cases,you will be able to find the correct position of the Remote Sender Cone so thatyou will not need to use the IR Extender. (see Figure A) When the Remote SenderCone cannot be easily placed in front of all of the components to be controlled, usethe IR Extender to help clearly direct the path of the IR signal to your components.(see Figure B) The IR Extender is best used to direct the IR signal to a singlecomponent. Follow these simple steps to set up the IR Extender.1. Plug the IR Extender into the back of the Remote Sender Cone.2. Place the IR Diode (located on the opposite end of the extension cord)in clear view of your component’s IR sensor to enable signal transmission.IR Extender SetupPerform Setup Routine and ProceduresThe SETUP key is located towards the lower right-hand side of the RCU1010RF remote. The SETUP keyis used to walk you through the steps in setting up the remote. To enter the Setup Mode, press and hold theSETUP key on the rubber keypad for 2-3 seconds until the LED indicator light remains on. Successive pressesof the SETUP key walk you through all the available setup routines. The following are the screen selectionsavailable in the Setup Mode.1. Code Setup Mode?2. Code Search Mode?3. Key Labels Mode?4. Set Smart Macro?5. Delete a Macro?(Only appears once a Macrofunction has been programmed.)6. Macro Key Delay Edit?(Only appears once a Macrofunction has been programmed.)7. Setup a Timer?8. Delete a Timer?(Only appears once a Timerfunction has been set.)9. Learn IR Mode?10. Delete IR Mode?(Only appears once an IRfunction has been learned.)11. Delete IR ALL?(Only appears once an IRfunction has been learned.)12. Set More Options?A. Set Time?B. Set Beep?C. Set LCD On Time?D. Set Light (Backlight) On Time?E. Set Volume TV<>AUDIO?13. Reset ALL?14. Exit SetupTo exit the Setup Mode, press and release the LCD EXIT key on the touchscreen. Then press and release theLCD OK key on the Exit Setup Screen or press and release the SETUP key repeatedly until the LCD displaysthe Exit Setup Screen. Press and release the LCD OK key. The remote is now in normal operation mode.Your RCU1010RF remote requires four AAA alkalinebatteries (sold separately).* Range may vary based on home construction.A.B.Install the BatteriesRCU1010RF_US_QS_revA 9/12/03 16:01 Page 2