Chapter 6 The Menu SystemChapter 6 The Menu System115Changing the Signal TypeThe Signal Type menu lets you choose whether you are receiving a signal fromcable TV or an off-air antenna. When you run Channel Search, the TV automaticallydetects your signal and you don’t have to specify it here. However, if you decide tochange the source, you will need to use the Signal Type menu.Note: When your LCOS HDTV is in DIRECTV mode, this menu isn’t available.Reminder:Make sure the Ch 2/3/4 switch on the back of thecomponent is set to the channel you specify in the AutoTuning screen.Select whether you are receiving signalsfrom an off-air antenna or cable.Auto TuningThis menu displays the various components you have connected to your TV. It letsyou program a component button on the remote control (VCR1, VCR2, or DVD) sothat pressing the button automatically turns on the component, turns on the TV, andtunes the TV to the correct video input channel.1. Press the arrow buttons on the remote control to highlight the rectangular fieldthat corresponds to the component.2. Press the OK button on the remote to choose the input channel the TV needsto tune to when you press that component button. Choices for eachcomponent are:Not Connected Select this if you don’t have the component connected to theantenna or video input jacks on the back of the TV, or if you don’t want the TVto tune to a channel when the particular component button (VCR1, VCR2, orDVD) is pressed.Ch 2 (or 3 or 4) - Ant A Select this if your component is connected toAntenna A on the back of the TV and you want the TV to tune to channel 2 (or3 or 4) when you press the component button (VCR1, VCR2, or DVD).Ch 2 (or 3 or 4) - Ant B Select this if your component uses Antenna B onthe back of the TV and you want the TV to tune to channel 2 (or 3 or 4) whenyou press the component button (VCR1, VCR2, or DVD).
